3Designing with NevoStudio Pro

Editing IR Devices Designing with NevoStudio Pro
4. Connect the controller that will learn the function to the design
computer by using the supplied USB cable or by using a wireless
network (if the controller is WiFi enabled).
5. Locate the remote for the device you want to learn from. Align the
source remote with Nevo, no further than 5 inches apart, preferably
between 2in and 5in (5.08cm and 12.7cm):
OK
2" - 5"
5.08cm - 12.7cm
Installer Tip: Make sure the IR Blaster for the source remote is close to Nevo
to minimize signal loss. You may need to prop the end of Nevo up
slightly so that the IR Blasters are aligned.
Installer Tip: Click Next. The Edit Device Wizard checks your Nevo
connection and puts Nevo in “learning mode”.
Installer Tip: Once NevoStudio Pro verifies the connection, Nevo will beep
twice; you then have five seconds to press the key to be learned on
the source remote. A single beep will sound after five seconds have
elapsed.
6. Press the key to be learned on the source remote. When Nevo beeps
twice and displays a success message, Nevo has learned the new
command.
Installer Tip: If the screen displays a red X instead, the command has not
been learned successfully. Press the Learn key on on Nevo to try
learning the command again, or Cancel to exit. We recommend
placing your finger on the key to be learned from the source
remote before clicking Learn; that way, you can press it as soon as
Nevo enters Learn mode.
Installer Tip: After the command has been learned, you can test the function
by pressing the Test key on Nevo. If you are not satisfied that the
command has been learned correctly, press the Learn key to
attempt to try to learn the command again.
7. Press the OK key on Nevo. NevoStudio Pro displays a confirmation
screen after the command has been successfully saved.
68 NevoStudio Pro Design Guide