3Designing with NevoStudio Pro

Configuring Nevo Ecosystems Designing a NevoLink Network
• one NevoLink for each room containing devices that Nevo S70 will
control (or more, if you have more than one enclosed cabinet with
devices in it)
• in-wall network cabling near where you must place NevoLink to be
within the IR range of the entertainment devices to be controlled:
180°
50’
15.24 m
IR Receiver on device
IR Receiver on device
50’
15.24 m
If this corresponds to the network, you can follow the connection
instructions in the NevoLink Quick Guide under “Basic Configuration”. You
will not need the IR Extenders or Switch Plugs in the NevoLink kit for this
topology.
Note: NevoStudio Pro includes updated NevoLink firmware with many
new features. As a result, firmware versions released prior to 6.11
are no longer supported in a Nevo network containing NevoStudio
Pro, or later, based program loads. When you set up a network, any
NevoLinks with firmware prior to 6.11 will show up in NevoStudio
Pro with an update icon. You can update a NevoLink by selecting it
and clicking on the Update NevoLink Firmware icon in the Nevo
Ecosystem tab. You can see the current MAC Address and firmware
version in the NevoLink properties dialog.
NevoStudio Pro Design Guide 151
30°