Networking

Rittal IT catalogue/Security
Programming cable
The interface cable is used to configure the network
parameters in the Processing Unit II and the
Master Unit.
The RJ 10 connector is connected to the front
jack of the PU/Master, whilst the 9-pole SUB-D
connector is connected to a serial PC interface.
Connection cable RJ 45
This cable is for data exchange and power supply
to a sensor unit via the Processing Unit II. There is
an RJ 45 connector at each end of the shielded
cable. Additionally, the cables are used for applications
with the CMC-TC Master II, extension unit
DK 7200.520 and SSC applications.
Connection cable
RJ 10, RJ 12
The RJ 12 connection cable allows the alarm relay
output of the Processing Unit II to be used for individual
alarm lights/indicators. The RJ 10 connection
cable facilitates connection to the CMC
socket strip in conjunction with the digital input
module. The cable is equipped with an RJ 10/12
connector at one end. The other end is open.
Extension cable
RJ 12
The cable is used to extend the sensor supply
cables (RJ 12) and individual actuator cables. The
cable is equipped at the end with an
RJ 10/12 connector. There is an RJ 10/12 jack at
the other end.
Example: RJ 12
6 1
Security
Connection/mounting accessories
Packs of Model No. DK
1 7200.221
Length m Packs of Model No. DK
0.5 4 7320.470
2 4 7320.472
5 4 7320.475
10 1 7320.481
15 1 7320.485
Connector Length m Packs of Model No. DK
RJ 10 5 4 7200.420
RJ 12 5 4 7200.430
Connector/jack Length m Packs of Model No. DK
RJ 12 5 4 7200.450
RJ 12 1 2 7320.814
169
Security