Networking

Rittal IT catalogue/System accessories
Angular baying brackets
The alternative to baying bracket TS 4582.500
and for individual interior installations.
Material:
Sheet steel, zinc-plated, passivated
Supply includes:
Screws M8 x 16 mm.
Combination angle
For optimum distribution of tensile forces during
transportation of bayed enclosures by crane.
Material:
Sheet steel, zinc-plated, passivated
Supply includes:
Assembly parts.
Baying attachment, vertical
for TS/TS with divider panel
Only suitable for mounting in conjunction with the
angle brackets of the divider panel (included with
the supply).
Material:
Sheet steel, zinc-plated, passivated
Supply includes:
Assembly parts.
Baying attachment, vertical
for TS/TS
For baying two populated enclosures on the
vertical enclosure section.
Simply locate into the vertical TS punchings,
secure and connect both brackets by using the
hex screws (supplied loose).
Using the fastening bolts, the enclosure is pulled
into a defined end position, with a height or side
offset of up to ± 2 mm.
Baying clamp, horizontal
for back-to-back mounting
Two-piece, for in situ assembly of enclosures
with mounting plate in the rearmost installation
position.
Material:
Sheet steel, zinc-plated, passivated
Supply includes:
Assembly parts.
Baying system
Packs of Model No. PS
4 4582.000
Baying
Also required:
For mounting on:
horizontal TS enclosure section
Captive nut/threaded block M8, see page 314,
vertical TS enclosure section
Snap-on nut M8, TS 8800.808, see page 310.
Packs of Model No. TS
4 4540.000
Accessories:
Baying cover,
see page 276.
Notes on the transport of bayed enclosures,
see page 274.
Packs of Model No. TS
8 8800.470
Note:
May also be used for side or wall attachment/fastening
of enclosures. In such cases, additional
holes must be drilled in the side or rear panel.
Packs of Model No. TS
6 8800.670
Material:
Sheet steel 3 mm, zinc-plated, passivated.
Supply includes:
Assembly parts.
Packs of Model No. TS
4 8800.170
German patent no. 10 157 979
275
Baying