Networking

Rittal IT catalogue/System accessories
Swing frame, large
without trim panel
for TS, ES
For mounting 482.6 mm (19″) equipment.
The installation accessories required for other
installation variants are described separately
(see page 374).
Technical specifications:
Torsionally stiff frame, welded from rectangular
tube and triple folded support section.
Material:
Sheet steel, zinc-plated
Supply includes:
2 cams with double-bit lock insert and parts for
attaching to the installation kit.
Note:
If the enclosure height is not fully utilised by the
swing frame, additional mounting accessories –
see page 374 – will be required.
482.6 mm (19″) installation
Also required:
Installation kit for swing frame, large,
see page 374.
Swing frames
Accessories:
Depending on the installation position:
TS punched section with mounting flange,
23 x 73 mm,
see page 299.
TS punched rail 18 x 38 mm,
see page 302.
Punched sections with mounting flanges,
see Cat. 31, page 926.
Width divider,
see Cat. 31, page 850.
Lock inserts, type D,
see page 285.
Height units 22 U 31 U 36 U 40 U 45 U
Model No. SR 2322.700 2331.700 2336.700 2340.700 2345.700
For enclosure height mm (or higher) 1200 1600 1800 2000 2200
H1 mm 1061.5 1461.5 1684.5 1861.5 2084.0
H2 mm 981.5 1381.5 1604.0 1781.5 2004.0
Installation depth T max. = mm with dimension D1) of at least 49 mm
Enclosure width mm 600 1200 1200
Mounting central left or right left and right
Enclosure depth mm
400
500
600
800
H1
H2
499
465
450
X
D
12
86.5
19
35
T max.
T max.
185
185
185
185
80
Cut-out “X”
44.45
7.5
T max.
295
395
495
695
1) D = Distance from the inner edge of the door to the front edge of the swing frame may be installed deeper on a 25 mm pitch pattern.
D
T max.
□ 9
15.9
31.8
D
T max.
T max.
295
365
365
365
373
Swing frames