Networking

Lock systems/hinges
Door/locks
Lock systems/hinges
Universal enclosure key
Double-bit, 8 mm square, 8 mm triangular (also
for 7 mm inserts), with integral screwdriver.
Spare key
for standard lock 12321 or 3524 E.
Quick-release fastener
for QuickBox
The quick-release fastener provides optimum
access, even when used in problem areas. To
facilitate locking, the quick-release fastener is
screw-fastened to the mounting bracket at the
front. This enables the QuickBox to be locked
even when the fasteners of the sides are opened,
allowing the enclosure cover to be attached and
removed easily.
Hinges 130°
for TS
For retrofitting a sheet steel door instead of the
rear panel.
Material:
Die-cast zinc
Supply includes:
Assembly screws.
Hinges 180°
for TS
For retrospective conversion of sheet steel doors
with 130° hinges.
One-person assembly:
● Exchange the hinge parts on the frame side for
180° hinges (4 screws).
● Drill the door at the pre-marked points.
● Screw-fasten the hinge parts onto the door.
● Locate the door.
● Press in the captive hinge pins.
Material:
Die-cast zinc
Supply includes:
Assembly screws.
Packs of Model No. SZ
1 2549.000
Design Packs of Model No. QB/SZ
12321 2 7526.050
3524 2 2532.000
Packs of Model No. QB
2 7502.220
Material:
Sheet steel, spray-finished
Colour:
RAL 7035
Supply includes:
2 mounting brackets, mounting material and
quick-release fasteners.
Packs of Model No. TS
4 8800.020
Also required:
Lock components for frame TS 8800.040,
see page 278.
Design Packs of Model No. TS
RAL 7035 4 8800.190
RAL 7032 4 8800.030
RAL 8019 4 8800.230
Matt nickel-plated 4 8701.180
Note:
Door assemblies such as the comfort handle may
restrict the door opening angle.
The hinge pins may only be actuated and the
door removed with the door open.
The hinge cannot be dismantled from the outside
with the door closed (access protection).
288 Rittal IT catalogue/System accessories