Networking

Swing frames
482.6 mm (19″) installation
Swing frames
5 examples for TS
Partial installation in 600 and 800 mm wide enclosures,
in the foremost or rearmost position.
1
Partial installation, centre
in 600 and 800 mm wide enclosures.
1
1
1
Front Set back
Front
2
2
2
1
1
Set back
Installation kit
for swing frame, small, or hinge attachment for
partial mounting plate in TS 8.
Material:
Cross member: Sheet steel, passivated
Support bracket TS: Die-cast zinc
Supply includes:
2 cross members,
assembly parts.
1
2
2
2
1
Also required:
Depending on the installation position:
1 Installation kit for swing frame, small.
2 PS punched section without mounting flange
23 x 73 mm according to the enclosure depth
in conjunction with 4 support brackets
TS 8800.330 (2 included with the supply of the
installation kit).
Note:
Height compensation between the 25 mm pitch
pattern of holes in the enclosure and the height
units of the swing frame is achieved by the support
brackets TS (two are included with the supply
of the installation kit).
Side installation
With an enclosure depth of 600 or 800 mm,
side installation of a small swing frame is identical
to installation parallel to the front.
For access to the swing frame we recommend
the hinges for the TS side panel,
see page 265.
372 Rittal IT catalogue/System accessories
1
1
Enclosure width
mm
Model No. SR
600 2377.860
800 2377.880
Accessories:
Depending on the installation position
(see above):
Support brackets TS 8800.330,
see page 312,
and PS punched sections without mounting
flanges to match the enclosure depth,
see page 304.