Networking

Cable routing
Cable management
Cable routing
Extension kit
horizontal cable mangement
for FR(i)
Allows the enclosure frame to be extended in the
depth by approximately 100 mm. The space
thereby acquired may be used for horizontal
cable management between bayed enclosures.
Material:
Sheet steel, zinc-plated, passivated
Supply includes:
1 set =
8 spacer supports, including assembly parts.
Mounting/cable management
panel
for QB 3 U, 6 U with vertical 482.6 mm (19″)
level
For structured cable routing or for mounting small
components or distributors (such as hubs,
switches etc.). The cable management panel is
easily fitted in the front of the rear panel from the
front.
Material:
Sheet steel, zinc-plated
Supply includes:
Assembly parts.
Cable route
Universal cable tray. Ideal for network enclosures
with large quantities of cable.
Extension kit
Packs of Model No. FR
1 set 7856.740
Note:
Combination of the extension kit with divided
doors is not possible.
Trim panels
Enclosure height mm Packs of Model No. FR
2000 2 7856.743
2200 2 7856.746
Note:
Upon request, trim panels may be inserted on the
outer sides of the bayed enclosure suites to protect
the enclosures against unauthorised access.
Width mm Length mm Packs of Model No. QB
485 450 1 7502.270
Accessories:
Nylon loop, see page 353.
Cable ties, see page 353.
Width mm Length mm Packs of Model No. DK
150 1700 1 7858.150
200 1700 1 7858.152
Material:
Sheet steel, zinc-plated, passivated
Supply includes:
300 1700 1 7858.154
Assembly parts. Accessories:
TS punched section with mounting flange,
see page 299.
Nylon loop, see page 353.
Cable ties, see page 353.
358 Rittal IT catalogue/System accessories