Networking

1
2
3
Rittal IT News/System accessories
Brush strip, super-airtight
For individual installation of enclosure panels,
gland plates and panels. Cut-outs for cable routing
at any position in the side panel, rear panel,
doors, roof and base plate.
These special brush strips may be used to create
airtight entries for cable sections and conductors.
The brush strips arranged in an offset configuration
ensure good sealing from the routed cables
even with large quantities of cables. In this way,
unwanted system losses may be reduced to a
minimum.
Cable routing bars
for 482.6 mm (19″) system punchings
For structured cable routing of entire cable bundles,
the cable bars may be secured to a variety
of different positions inside the enclosure. These
routing bar elements are particularly suitable for
use in 600 mm wide server racks or in bayed
systems where side access is restricted.
Thanks to their open mounting holes, they can
also be retrospectively slotted onto the 482.6 mm
(19″) system punchings of the mounting level at
any time and secured with the existing mounting
screws of the installed components.
Individual cable routing bars may be extended by
baying to create entire systems using a connection
comb.
1
2
3
Cable routing bar, 4 U
for 482.6 mm (19″) system attachment
For horizontal cable routing within the distributor
level.
Cable routing bar, 1 U
for 482.6 mm (19″) system attachment
For cable routing of individual cable bundles
within the mounting level or to the installed
components.
Connection comb
For connecting individual cable routing bars
into complete systems.
System accessories
Packs of Model No. DK
2 x 1 m 7825.375
Material:
Brush strip: Plastic, UL 94-V0
Supply includes:
Each 1 brush strip,
1 m in length, right-hand and left-hand version.
Packs of
3
No. of
connection combs
Model No. DK
1 4 2 7111.224
2 10 5 7111.214
Material:
Support: Sheet steel
Cable routing bars, connection combs: Plastic
Colour:
RAL 9005
Supply includes:
Cable routing bars and connection combs.
455
Innovations