Networking

Rittal IT catalogue/System accessories
Swing frame,
482.6 mm (19″)
Heavy-duty version
for 800 mm wide enclosures, based on TS 8
The swing frame facilitates the accommodation
of a wide range of 482.6 mm (19″) components
up to a weight load of 350 kg. By swinging it out,
access may be gained to the rear of the equipment
and its cabling at any time. The maximum
opening angle is 130°.
At the side, the swing frame has a trim panel with
integral handle strip and two-point locking bar.
A semi-cylinder lock can be achieved by using
the Ergoform-S handle system.
Several openings in the trim panel permit convenient
cable routing from the rear of the swing frame
in the front section. The openings may also be
optionally top-mounted with standard commercially
available plastic cable ducts.
An additional vertical row of holes integrated into
the trim panel facilitates vertical and horizontal
cable routing via cable shunting rings.
Installation is only possible in the form of full
enclosure installation. The installation position
may be varied in the enclosure depth.
Swing frame stay
Holds the swing frame in the open position.
For mounting on:
Swing frame, large
● SR 1979.200, at the top of the enclosure
● SR 1980.200, at the bottom of the enclosure
(with safety catch at 160°)
For mounting on:
Swing frame, small
● SR 1979.200, may be mounted at the top or
bottom of the installation kit.
Slide rails
To support heavy slide-in electronic equipment,
482.6 mm (19″) in the swing frame.
Material:
Sheet steel, zinc-plated
482.6 mm (19″) installation
Swing frames
U
For enclosure height
mm
Model No. DK
40 2000 7858.100
Load capacity:
350 kg
Material:
Swing frame: Sheet steel, zinc-plated, passivated
Trim panel and installation kit: Sheet steel,
spray-finished, RAL 7035
Supply includes:
Locking rod with double-bit lock insert, heavyduty
installation kit and assembly parts.
Note:
Max. installation depth of the equipment Tmax.,
see page 375 (swing frame, large, with trim at
the side).
Packs of Model No. SR
With 130° hinge 5 1979.200
With 180° hinge 1 1980.200
For equipment with a
max. installation depth
Packs of Model No. SR
T max. < 190 mm 10 1962.200
T max. > 190 mm 10 1963.200
377
Swing frames