Networking

Rittal IT catalogue/System accessories
Depth stays as installation kit
for mounting angles, 482.6 mm (19″)
Installation in enclosure width 800 mm
One installation kit consists of 4 depth stays to
accommodate mounting angles. One pack is
sufficient for installing one or two 482.6 mm (19″)
attachment levels. For exceptionally heavy
installed equipment, we recommend the installation
of an additional depth stay in the centre. The
front cut-out makes cable routing easier with full
configuration
Material:
Sheet steel, zinc-plated, passivated
Supply includes:
Assembly parts.
Depth stays for TS
for mounting angles, FR(i), 482.6 mm (19″)
Installation in enclosure width 800 mm
Depth stays are screw-fastened to the enclosure
frame in the enclosure width.
The mounting angle is attached to the depth stay
at the top and bottom. The depth stay ensures
optimum clearance at the sides for cable routing.
For partial enclosure configuration, the depth
stays may be attached to the TS punched sections
with mounting flanges 17 x 73 mm on the
outer attachment level of the enclosure frame.
Fully depth-variable attachment is facilitated by
the attachment slots. Either cranked or L-shaped
mounting angles may be used.
Material:
Sheet steel, zinc-plated, passivated
(DK 7827.480)
Sheet steel, spray-finished in RAL 7035
(DK 7827.490)
Supply includes:
Assembly parts.
482.6 mm (19″) installation
Mounting kits for mounting angles
Width
mm
For enclosures
Depth
mm
Packs
of
Possible
alternative:
Depth stays TS for mounting angles,
see page 369.
Model No.
DK
800 600 4 7827.600
800 800 4 7827.800
800 900 4 7827.900
800 1000 4 7827.000
Packs of
Model No. DK
Installation position
central side
2 7827.480 7827.490
Accessories:
For partial installation,
TS punched section with mounting flange,
17 x 73 mm,
see page 299 – 300.
Mounting angles, cranked or or L-shaped,
see page 364.
369
Mounting kits for mounting angles