Networking

Rittal IT catalogue/System accessories
Aluminium rivet
For secure assembly of cable ducts in conformity
with the relevant standards. Also suitable for
mounting support rails and punched rails. Simple
mounting using hand-held rivet tool TS 8800.532.
To fit:
● TS system punchings
● Drilled hole Ø 4.5 mm.
Hand-held rivet tool
for aluminium rivets
Reaches even poorly accessible rivet points in
narrow or deep cable trunking. In conformity with
the standard, the aluminium rivets are made without
burrs, sharp edges or rough surfaces.
Plastic rivet
Easily mounted with a standard commercially
available blind rivet tool.
For fastening the cable ducts in the
● TS system punchings
● Drilled hole Ø 4.0 mm
C rails
may be found under rail systems
from page 306.
Cable clamp rails
see page 354.
Cable management
Accessories:
Cable ducts for vertical TS section,
see page 350.
Cable ducts for mounting plate,
see Cat. 31, page 978.
Cable routing
Packs of Model No. TS
100 8800.531
Packs of Model No. TS
1 8800.532
Packs of Model No. TS
100 8800.530
351
Cable routing