Networking

Cable routing
Cable management
Cable routing
Cable tie fastener
for round system punchings
For all commercially available cable ties up to a
tie width of 4.8 mm.
Simply insert into the round system punchings or
into the screw channel, and secure by hammering
down the split rivet.
Material:
Polyamide 6.6
Cable clamp rails
for TS and 482.6 mm (19″) mounting frames
The cables may be attached to the cable clamp
rails with cable ties or nylon tapes. The cable
clamp rails are simply located onto the frame section
and may additionally be secured with a
screw.
Material:
Sheet steel, zinc-plated, passivated
Supply includes:
Assembly parts.
Accessories:
Cable ties, see page 353.
Nylon loop, see page 353.
Cable clamp rails,
depth-variable
for TS and 482.6 mm (19″) mounting frames
For strain relief of the routed cables. The cables
may be attached to the cable clamp rails with
cable ties or nylon tapes.
The cable clamp rails may be located directly on
a 482.6 mm (19″) mounting frame horizontally at
the rear or in the enclosure depth between two
mounting frames. An additional screw-fastening
secures the unit.
The depth variability of the rails facilitates flexible
adaptation of their length to the existing attachment
distance between the two 482.6 mm (19″)
mounting frames.
Material:
Sheet steel, zinc-plated, passivated
Supply includes:
Assembly parts.
Packs of Model No. CP
100 6059.000
For the inner mounting level
For enclosures
Width mm Depth mm
Packs of
Model No.
DK
600 600 4 7828.061
800 800 4 7828.081
900 900 4 7828.091
1000 1000 4 7828.101
1200 1200 4 7828.121
For the outer mounting level
For enclosures
Width mm Depth mm
Packs of
Model No.
DK
600 600 4 7828.062
800 800 4 7828.082
900 900 4 7828.092
1000 1000 4 7828.102
1200 1200 4 7828.122
Distance between
19″ levels
mm
Packs of Model No. DK
325 – 575 4 7858.160
500 – 895 4 7858.162
Accessories:
Cable ties,
see page 353.
Nylon loop,
see page 353.
354 Rittal IT catalogue/System accessories