Networking

Rittal IT catalogue/System accessories
Section for cable entry,
centre
for TS, CM, FR(i)
For top-mounting on the gland plates. The better
alternative to the foam rubber cable clamp strip,
thanks to:
● Easier mounting
● Full-surface support
● High level of sealing of cables inserted into the
enclosure
Material:
Extruded aluminium section,
PU foam seal,
cross-section: 30 x 25 mm
Protection category:
IP 55 if mounted correctly.
Supply includes:
1 set =
2 sections for base plate,
each with bonded seal.
Section for cable entry, rear
for TS, CM, FR(i)
Unlike the section for cable entry, centre, the rear
section is mounted directly onto the base opening.
In this way, when installing the mounting plate
in the rearmost position (TS) or with CM, the
cables may be routed directly on a cable clamping
rail with no large radii.
Material:
Extruded aluminium section,
PU foam seal,
cross-section: 30 x 25 mm
Protection category:
IP 55 if mounted correctly.
Foam rubber cable clamp strip
For sealing the cable entry between the gland
plates. Particularly suitable for identical cable
cross-sections.
Material:
Seal PU foam,
cross-section: 30 x 30 mm
Protection category:
IP 55 if mounted correctly.
Cable management
Cable entry/gland plates
For
enclosure width
mm
Packs of Model No. TS
600 1 set 8802.060
800 1 set 8802.080
1000 2 sets 8802.100
1200 2 sets 8802.120
Y
129.5
24.5
30 x 25
Y = Mounting plate depth-adjustable on a
25 mm pitch pattern (final pitch 30 mm).
For
enclosure width
mm
Packs of Model No. TS
600 1 set 8802.065
800 1 set 8802.085
1000 2 sets 8802.105
1200 2 sets 8802.125
Supply includes:
1 set =
1 section for base opening,
1 section for base plate,
each with bonded seal.
5
25.5
Packs of Model No. SZ
3 m 2573.000
341
Cable entry/gland plates