Networking

1
3
43
63
Rittal IT catalogue/System accessories
Mounting angles,
482.6 mm (19″)
for TS, ES
For the installation of subracks and other equipment.
Mounting angles are easily shortened for partial
assemblies.
Surface finish:
Conductive, corrosion-protected coating.
Supply includes:
Assembly parts.
For
enclosure height
mm
Packs
of
For enclosure system
TS 1)
U
482.6 mm (19″) installation
Aluminium
section
U
Mounting angles
Note:
Assembly example,
see page 367.
For the installation of the 482.6 mm (19″)
component shelves, see page 319,
the installation kits, see page 324, are required.
Accessories:
Infill panels,
see page 380.
Captive nuts,
see page 381.
Assembly screws,
see page 382.
Slide rails with one-sided mounting,
see page 383,
Slide rails with two-sided mounting,
see page 383.
Aluminium
section
For enclosure system
ES
Sheet steel,
spray-finished,
RAL 7035
Sheet steel,
zinc-plated,
passivated
Model No. TS Model No. PS
1600 4 33 8613.060 33 4389.000 – –
1800 4 38 8613.080 37 – – –
2000 4 42 8613.000 42 4391.000 4358.200 –
2200 4 47 8613.020 46 – – 4358.700
For PC enclosure2) 4 17 8613.070 17 4632.000 – –
1) For the rear of electronic enclosures.
2) Behind bottom door.
Assembly examples of TS:
Drawing 1 Drawing 2 Drawing 3 Drawing 5
Drawing 1 and 2:
Mounting angle or adaptor piece fitted in the foremost installation
position, directly on the vertical section.
When installing slide rails with two-sided mounting (see page 383),
the same mounting angles or adaptor pieces must also be
mounted on the vertical section at the rear.
1 Mounting angles/piece
2 Adaptor rail
3 TS sheet steel door
4 TS glazed door
5 Punched section without mounting flange
1
4
63
75.5
Drawing 4
5
2
1
3
66
86
Drawing 3:
Mounting on two vertically
installed PS punched sections
permits fully flexible use of the
enclosure depths.
1
2
4
86
98.5
Drawing 4 and 5:
Greater distance from the door
is achieved by mounting on
adaptor rails for PS compatibility.
In this position, the slide rails
can be fitted with one-sided
mounting.
367
Mounting angles