Masoneilan SVI II AP Installation and Maintenance ... - GE Energy
Masoneilan SVI II AP Installation and Maintenance ... - GE Energy
Masoneilan SVI II AP Installation and Maintenance ... - GE Energy
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
VIEW ERR Diagnostics Messages<br />
Using the Digital Interfaces<br />
Table 11<br />
Error Messages<br />
LCD Description Action Cause<br />
RESET<br />
Reset occurred due to comm<strong>and</strong> or power up. Always<br />
present after power up.<br />
Warning<br />
Normal operation<br />
on power up<br />
always sets<br />
RESET. RESET is<br />
sent by HART<br />
communications.<br />
Use CLEAR ERR<br />
to remove warning<br />
LOW<br />
POWER<br />
Input current < 3.6 mA<br />
Takes the device<br />
to low power<br />
ACT ERR Positioner unable to position a valve normally Warning<br />
AIR LOW<br />
Supply pressure option is configured <strong>and</strong> supply<br />
pressure is < 10 psi (.69 bar, 69 kPa). Otherwise I/P<br />
pressure is below 0.8 psi (.05 bar, 5.5 kPa)<br />
Warning<br />
Mechanical or<br />
pneumatic problem<br />
POS ERR<br />
The position error exceeds configured limit for more<br />
than configured time<br />
Warning after T1<br />
<strong>and</strong> Failsafe<br />
Pneumatic/<br />
mechanical,<br />
configuration,<br />
loose magnet<br />
KEYBOARD LCD/Button Failure Warning Damaged buttons<br />
or LCD electronics<br />
MARGN<br />
PWR<br />
Input signal is insufficient to proceed<br />
CALIB ERR Calibrate failed Warning Invalid values for<br />
current calibration<br />
<strong>and</strong> input range by<br />
HART comm<strong>and</strong>s<br />
STOP ERR Calibration error. Find STOPS was unsuccessful. Warning Configuration,<br />
calibration<br />
TUNE ERR Auto tune failed Warning Mechanical or<br />
pneumatic problem<br />
causes tuning<br />
failure<br />
STD DIAG A st<strong>and</strong>ard diagnostic procedure failed to complete Warning Pneumatic /<br />
mechanical,<br />
configuration<br />
85
Change language