Picture Perfect 4.6 User Manual - UTCFS Global Security Products

Chapter 7
Alarm/activity configuration
109
Figure 45.Route Point Form
Fields and controls
Table 49. Route Point form fields
Field
Route Definition
Facility
Route To Operators
Description
This field identifies the current route point’s route definition. Click the Route Definition button to
display a list box. Select the desired Route Definition, and then click OK. Example: Building A
Click Facility to display the facilities list box. This field reflects the facility to which this record is
assigned. For more information, see Creating facilities on page 52.
This field identifies the operators to whom the message is routed. A list of selected operators is
displayed. To add an operator to the list, click the arrow on the Operator drop-down list. One or
more operators may be selected for this route point. As operators are selected or unselected
from the list box, the Route to Operator window is updated.
Note:
This is not a required field; however, if no operators are selected, alarms with this route
point’s route definition cannot be responded to.
Ignore this field if you are creating a route point that is used only for Activity Monitor routing.
Bump to Operators
This field identifies an alternate operator if the message is not responded to within the time
specified in Bump Time. A list of selected operators is displayed. To add an operator to the list,
click the arrow on the Operator drop-down list. One or more operators may be selected for this
route point. As operators are selected or unselected from the list box, the Bump to Operator
window is updated.
Note:
This is not a required field; however, if no operators are selected, alarms with this route
point’s route definition are not bumped.
Ignore this field if you are creating a route point that is used only for Activity Monitor routing.