Picture Perfect 4.6 User Manual - UTCFS Global Security Products

Chapter 14
Reports
299
# sqlstmt "update report_setup set page_width=132 where
title=''"
3. You can verify the change took place by doing the following:
# selectrpt "select title, page_width from report_setup where
title=''"
4. Optional procedure if using wide paper: Configure enscript to use wide paper when printing.
Enscript, by default, uses Letter size paper. To use a different paper size, a configuration file
must first be edited. All dimensions of paper size are measured in points. A printer's point is
approximately 1/72 of an inch. The following is an example using a wide carriage printer with
wide track paper (14in x 11in):
On Linux, edit the file called /etc/enscript.cfg. Find the Letter line in "Media
definitions" section, it looks as follows:
# name width height llx lly urx ury
Media: Letter 612 792 24 24 588 768
Change the width of this type of paper as follows:
Media: Letter 1008 792 24 24 984 768
On AIX, edit the file called /usr/lib/ps/MediaSizes. Find the Letter line, it looks as
follows:
# Name Width Depth llx lly urx ury PageRegionName PaperTrayName
Letter 612 792 18 17 597 776 letter
Change the width of this type of paper as follows:
Letter 1008 792 18 17 990 776 letter
Save the file, and then exit. Schedule a report and verify the printout. If it says no data to
print, it usually means that the report is too wide or the SQL syntax is not right for the
report event, refer to Wide carriage printing of report events on page 298.
Note:
Wide carriage printing of Report Events was tested with an Okidata Printer.