Picture Perfect 4.6 User Manual - UTCFS Global Security Products

182
Picture Perfect 4.6
User Manual
Table 81. Doors form fields (continued)
Field
Door Sensor
Description
Click Door Sensor to display the Input list box. Select the desired input for this door sensor. A door sensor
is associated with a digital input (DI) point connected to a door sensor.
Note:
Select a door sensor input that is wired to the same micro as the associated door strike output.
The system displays an operator message if you select an input point on the wrong micro. Do not
attach an input group to the input unless the input is a supervised input.
Exit Button
Click Exit to display the Inputs list box. Select the desired input for this exit button. Be sure the Exit Button
Asserts Strike field (in the Door Control box) is set to Enabled.
Note:
Select an exit button input that is wired to the same micro as the associated door strike output.
The system displays an operator message if you select an input point on the wrong micro. Make
sure the exit input is tied to the reader’s valid input group.
Forced
Open In
Group
Click to display the Input Groups list box. Select an input group to activate. The associated alarm is
triggered when a Forced Open condition occurs. (Be sure the Forced Open Monitoring field is set to
Detected.)
Note:
Only Trigger on Input (non-boolean) input groups are displayed in the list boxes.
Held Open
In Group
Click to display the Input Groups list box. Select an input group to activate. The associated alarm is
triggered when a Held Open condition occurs. (Be sure the Held Open Sensing field is set to Detected.)
Note:
Only Trigger on Input (non-boolean) input groups are displayed in the list boxes.
Pre-Alarm In
Group
Click to display the Input Groups list box. Select an input group to activate. The associated alarm is
triggered when a Pre-Alarm condition occurs. (Be sure the Pre-Alarm field is set to Enabled.)
Note:
Only Trigger on Input (non-boolean) input groups are displayed in the list boxes.
Door State
Scheduling
Held Open
Sensing
Forced
Open
Monitoring
Exit Button
Asserts
Strike
Pre-Alarm
Indicate whether the door is normally Locked (pending a valid badge read or other event) or Unlocked.
Select Enabled to allow scheduled changes set for this door to take place. Select Disabled to prevent
scheduled changes set for this door from taking place.
Select Detected to allow an alarm condition to occur on this door when the door remains open (with a valid
badge reader or exit button) for too long, based on the Allowable Open Time (set in the Door Values box).
Select Ignored if the sensing function on this door is not used.
Select Detected to allow an alarm condition on this door to occur immediately when the door is forced
open without a valid badge read or exit device. Select Ignored if the Monitoring function on this door is not
used.
Select Enabled to allow an exit button to unlock this door for the number of seconds in the Unlock Time
field and remain open for the number of seconds in the Allowable Open Time field (both set in the Door
Values box). Be sure to make a selection in the Exit Button field in the Inputs box. Select Disabled if an exit
button is not allowed to unlock this door but will shunt the door DI.
Select Enabled to allow the Pre-alarm Notification feature to activate. See Pre-alarm notification on
page 373 for details on this feature. Select Disabled if the Pre-alarm Notification feature is not used.
Note:
Input groups for the above can be generic, that is, one input group and alarm can be used by all
doors for forced, held, and pre-alarm.
Keypad
Alarm
Response
Select Enabled to allow the Keypad Alarm Response feature to activate. See Controlling alarms using a
keypad code on page 376 for details on this feature. Select Disabled if the Keypad Alarm Response
feature is not used.