Picture Perfect 4.6 User Manual - UTCFS Global Security Products

Chapter 4
Setup
61
su - root
4. Type the following command to enable SSL:
DbSecComm 1
Enter
5. Log on to the system as ppadmin.
6. Start Picture Perfect again by typing:
rc.pperf
Enter
If this is a redundant configuration, start Picture Perfect by typing:
pprscmd start
7. Log on to the Picture Perfect application.
8. Check the Picture Perfect log file for database errors by typing the following command:
logtail
Enter
9. Press CTRL C to exit and return to the command prompt.
10. Query the database by typing:
query operator
Enter
Observe the output. If an error occurs due to the CSM module or Picture Perfect
configuration, it may appear here. The correct output resembles the following:
1 Systems Adminstrator 0000 install 1 1 -1
89fb511ffe93ee7826661ca1e3bb468dc1ad0ff2 0 0 1 1 -1 20041006
170806 -1 System System system 1 1 -1 0 0 -1 20041018
194738
To deactivate database SSL encryption:
1. Log on to the system as ppadmin.
2. At the command prompt, stop Picture Perfect by typing:
rc.pperf -k
Enter
If this is a redundant configuration, stop Picture Perfect by typing:
pprscmd stop
3. Log on to the system as root by typing:
su - root
4. Type the following command to disable SSL:
DbSecComm 0
where 0 = zero.
Enter
5. Log on to the system as ppadmin.
6. Start Picture Perfect again by typing:
rc.pperf
Enter