Picture Perfect 4.6 User Manual - UTCFS Global Security Products

332
Picture Perfect 4.6
User Manual
To set up the area doors:
Note:
The door sensor input and the door output must be physically connected to the same micro.
1. From the Configuration menu, select Doors and Readers, and then click the Doors tab.
2. From the toolbar, click Find to locate the door record you want to set up.
3. On the Inputs and Outputs tab, click Door Sensor Input.
Figure 152.Doors form: Inputs and Outputs
4. Select the appropriate input from the list displayed.
5. Click Save and exit the Doors form.
To enable Occupancy Control:
1. From the Control menu, select Operators, and then click the Facility Permissions Profile
tab.
2. From the toolbar, click Find to locate the Facility Permission profile record you want to
modify.
3. Under Page Level Permissions, click on Areas and make sure the level of permission is set
to Update.
4. Under Control Level Permissions, click on Occupancy Control and make sure the level of
permission is set to Update.