Picture Perfect 4.6 User Manual - UTCFS Global Security Products

366
Picture Perfect 4.6
User Manual
outputs (and inputs in the case of Reader/DI/DO configurations) to the corresponding floors. Perform
this setup for each of the access-controlled elevators in your facility.
Figure 181.Elevator Form
Fields and controls
Table 132.Elevators form fields
Field
Description
Facility
Configuration
Type
Micro
Reader
Fire DO after
Floor
Selection
Description
Type any alphanumeric combination to describe the elevator (up to 60 alphanumeric characters).
Example: Lobby, East Wing 1, West Wing 3
Click Facility to display the facilities list box. This field reflects the facility to which this record is assigned.
For more information, see Creating facilities on page 52.
Select one of the following types:
• Micro/DO - See To set up Example 2 in a Micro/DO configuration: on page 369.
• Reader/DO - See To set up Example 2 Reader/DO configuration: on page 369.
• Reader/DI/DO - See To set up Example 2 in a Reader/DI/DO configuration: on page 370.
When using the Micro/DO configuration type, click to select a micro from the list box. If multiple readers
are configured on an elevator micro, the first reader controls the elevator.
When using the Reader/DO or the Reader/DI/DO configuration type, click to select a reader from the list
box.
When using the Reader/DI/DO configuration type, select the Fire DO after Floor Selection to enable
Elevator Access Method 2 in which, after a valid badge read, a floor has to be selected and if it is an
accessible floor, the DO is activated. Otherwise, the default Method 1 in which, after a valid badge read,
the DOs for all accessible floors are activated, is employed.
CAUTION: Whenever the Fire DO after Floor Selection option is toggled and the change is saved on the
Elevator form, the micros reset. The duration of the reset depends on the number of badges defined in
the system.