User Guide - Eurotherm Ltda

nanodac RECORDER/CONTROLLER: USER GUIDE4.7 ADVANCED LOOP CONFIGURATIONSimilar to the Loop option described above, advanced loop includes the ability to run a cascade loop.Figure 4.7 is an overview of the configuration menu structure.Advanced LoopMain(Section 4.7.1)Setup(Section 4.7.2)Tune(Section 4.7.3)Master PID(Section 4.7.4)Slave PID(Section 4.7.5)Master PVMaster WSPTarget setpointSlave PVSlave WSPWorking OutputCascade ModeInhibitMaster Int.HoldSlave Int.HoldMaster NameSlave NameMaster LoopCascade TypeSlave Channel 1Slave Channel 2Setpoint accessMode AccessMan.Out AccessTune TypeTune EnableTune Slave R2GTune HighTune LowOutput HighOutput LowStateStage TimeDiagnosticsControl ActionPB UnitsDerivative TypePBTiTdCBHCBLMRLBTControl ActionPB UnitsDerivative TypeSched TypeNo of setsRemote inputSet boundariesPBTiTdR2GCBHCBLMRLBTOutput LowOutput HighMaster SP(Section 4.7.6)Range HighRange LowSP SelectSP1SP2SP High LimitSP Low LimitAlt SP EnableAlt SPRateRate DoneSP TrimSP Trim HighSP Trim LowManual TrackSetpoint TrackTrack PVTrack SPSP Int BalanceSlave SP(Section 4.7.7)Range HighRange LowSP High LimitSP Low LimitLocal SPAlt SPRemote FFRemote FF EnableRemote FF HighRemote FF LowManual TrackOutput(Section 4.7.8)Output HighOutput LowCh1 OutputCh2 OutputCh2 DeadbandRateSbrk ModeSbrk OPSafe OPManual ModeManual OutputForced OutputManual StartupPff EnLine VoltageCool TypeFF TypeTrack OutputTrack EnableRem. Output LowRem. Output HighDiagnostics(Section 4.7.9)Master ErorSlave Error(M)Prop. Output(M)Integral Out(M)Deriv. Output(S)Prop. Output(S)Integral Out(S)Deriv. OutputTarget OutputLoop Break (S)Loop Break (M)Sensor Break (S)Sensor Break (M)Sched PBSched Ti/TdSched CBH/CBLSched MRSched Loop BreakSched R2GSched Out HighSched Out LowWorking Out LowWorking Out HighPage 106HA030554Issue 7 Nov 12