User Guide - Eurotherm Ltda

nanodac RECORDER/CONTROLLER: USER GUIDEC2.3 PC SETUP1. Operate the ‘Start’ button, and select ‘Control Panel’ from the window thatappears. Double click on ‘Windows Firewall’2. Click on the ‘Exceptions’ tab in the window that appears, and checkthat both ‘FTPControl’ and ‘FTPData’ are enabled (ticked). If not, theuser’s IT department should be contacted for advice.3. Click on ‘Add Program...’ and browse to the Filezilla destinationdefined in step 7 of the download section (C2.1). Select ‘FileZillaserver.exe’ and click on ‘Open’‘FileZilla server.exe’ appears in the Exceptions list.Click on ‘OK’C2.4 RECORDER/CONTROLLER SET UPIn Network Archiving (section 4.2.2):1. Enter the IP address of the pc in which the FTP server has been enabled in the ‘Primary Server’ field.2. Enter the Primary User name, as entered in step three of the Server setup procedure (section C2.2)above (GeneralUser in this example).3. Enter the IP address of another suitable pc which has been configured as an ftp server in the ‘Sec.Server’ field, and enter the relevant ‘Sec. User’ name.4. Configure the other unattended archive parameters as required (section 4.2.2).Note: For the example above, ‘Password’ was not enabled in the User Accounts setup page (sectionC2.2), so for this example any Primary (Sec.) password entry is ignored. If a password had beenentered in the User Accounts setup, then the Primary (Sec.) Password field would have to containthis password.HA030554Issue 7 Nov 12Appendix CPage 331