User Guide - Eurotherm Ltda

nanodac RECORDER/CONTROLLER: USER GUIDE4.2.1 Interface (Cont.)GatewayRead only if ‘IP Type’ = ‘DHCP’.If ‘IP Type’ = ‘Fixed’ this allows the user to enter a gateway address for use when the unitis to communicate outside the local network. Normally supplied by the user’s IT department,or from the Network supervisor.4.2.2 ArchivingThis area of configuration is used to set up the parameters for use during unattended archiving. Some ofthe fields appear only if other fields are set to a particular value. For example, the CSV fields appear only if‘File Format’ is set to ‘CSV’ or to ‘Both’.The archived data is not removed from the flash memory of the instrument. When the flash memory is full,new data causes the oldest file(s) to be discarded.Note: For remote archiving, the host computer must be set up to respond to ‘pings’. This isbecause the nano pings the host whilst establishing connection, and if it does not receive a responsethe archive attempt fails.Network.ArchivingNetwork.ArchivingMedia SizeMedia FreeMedia DurationRateDestinationFile FormatOn Media Full1907.46 MB1902.90 MB763.77 DaysAutomaticFTP serverBinary (UHH)OverwriteRateDestinationFile FormatCSV ValuesCSV MessagesCSV HeadersCSV HeadingsMonthlyUSBBothYesNoNoYesRemote Path /archivePrimary Server 123.123.123.123Primary User historyPrimary Password ******Sec. Server 234.234.234.234Sec. User anonymousSec. Password ****Trigger NoPeriod NoneRemote with Binary file formatCSV Date FormatCSV Tab DelOn Media FullRemote PathPrimary ServerPrimary UserPrimary PasswordSec. ServerSec. UserSec. PasswordTriggerPeriodTextNoOverwrite/archive123.123.123.123history******234.234.234.234anonymous****NoNoneLocal with CSV files includedFigure 4.2.2a Unattended Archive configuration (typical settings)Media SizeMedia FreeMedia DurationHA030554Issue 7 Nov 12Appears only for File Format = ‘Binary (UHH)’. A read only value showing the capacityof the memory stick inserted in the USB port at the rear of the unit. Shows zero if nomemory stick is present.Appears only for File Format = ‘Binary (UHH)’. A read only value showing the space remainingin the memory stick inserted in the USB port at the rear of the unit. Shows zeroif no memory stick is present.Appears only for File Format = ‘Binary (UHH)’. A read only value showing the time it willtake to fill the Memory stick if the recorder configuration remains unchanged.Page 73