User Guide - Eurotherm Ltda

nanodac RECORDER/CONTROLLER: USER GUIDEE Appendix E: WEB SERVERThe Web Browser has been added from firmware release V5.00.E.1 BrowsersThe following browsers are supported in the above firmware release:• Google Chrome V22.0 or greater• Google Mobile Chrome (Android Mobile technology running ‘Ice cream sandwich’ or greater• Internet Explorer V9.0 or greater• Mobile Safari (Apple Mobile technology running IOS 5.0 or greater)All files are uploaded from the nanodac device to the browser, where all JS and JQuery files are executedlocally.Browsers should be configured to allow cookies, and support for file caching should also be enabled.If cookies are not enabled this will have the following detrimental effects:• Any web page configuration changes ‘saved’ by the user in the client browser will not be retained whennavigating between web pages• For the most efficient browsing make sure that caching is enabled in the browser being used.• Web server supports standard ASCII character set. Any non displayable characters will, therefore, bereplaced by an asterisk ‘*’.E.1.1 Connecting to the InternetOpen the desired web browser.Enter the ethernet address or other configured name of the instrument.E.1.2 Denied PageThis page will be displayed when there are no moreavailable connections to the server. It does not usethe same CSS theme as all other pages, so that thispage does not rely on any other files being transferredup to the client browser, since to do thiswould require access to the server, which has justbeen denied.E.1.3 Error MessageAn error message can be displayed at any time ifthe following three conditions occur:• A page fails to connect to the server. A retry willusually be sufficient to correct this condition• The server is in configuration mode. To correctthis put the instrument into run mode.• A page stops trying to connect. A refresh is usuallysufficient to correct this condition.HA030554Issue 7 Nov 12Appendix EPage 351