User Guide - Eurotherm Ltda

nanodac RECORDER/CONTROLLER: USER GUIDE4.1.3 Display configurationThis allows the user to set display brightnesses and screen saver details, to select a display mode as the‘Home’ page, and to enable/ disable the various display modes. The normal ‘Select, Scroll, Enter’ editingtechnique is used as has been previously described.Instrument.DisplayBrightnessSave AfterSaver BrightnessHome PageHPage TimeoutVertical TrendHorizontal TrendVertical BarHorizontal BarPromote ListTrend BackgrndHistory BackgrndH.Trend ScalingFaceplate CyclingSetpoint ColourNumber FormatUSB Auto Scan70%7 min50%V.TrendOffBlackDarkGreyHideOffRedRoundedNoHome page(always enabled)Mode disabledMode enabledFigure 4.1.3 Display menu (expanded to show all fields)BrightnessSave AfterSaver BrightnessHome pageHPage TimeoutVertical TrendAllows the user to select a normal operating brightness for the screen from 10% to100%, in 10% steps.The elapsed time (since last button press) before the screen switches from ‘Brightness’to ‘Saver Brightness’. (Off = saver function disabled)The screen saver brightness. Valid entries are 10% to 100% inclusive, in 10% steps. Usinga lower power when not ‘in use’ not only saves power, but also increases display life.Typical screen power consumption is 0.5W at 100%, falling in a linear fashion to 0.05Wat 10%.Allows any display mode to be chosen as the ‘Home’ page. This is the page that therecorder displays at power up, and also the page displayed when the ‘Home’ key is selectedfrom the top level menu (Section 3.3. The selected display mode (vertical trendin figure 4.1.3) is always enabled in the following display mode enable fields (its ‘tick’is greyed out and cannot be edited). See Section 3.4 for a description of the availablemodes.The elapsed time (since last button press) before the display returns to the homescreen. (Off = disabled)This is the default home page, and its tick is greyed. If this is not the home page, thetick can be changed to a cross, by highlighting it and operating the scroll button.* CNOMO = Comité de normalisation des moyens de production.Page 60HA030554Issue 7 Nov 12