User Guide - Eurotherm Ltda

nanodac RECORDER/CONTROLLER: USER GUIDE4.1.4 Info menuGives information about the recorder hardware and software, and allows the user to enter a descriptor forthe instrument. The normal ‘Select, Scroll, Enter’ editing technique, previously described) is used to editthose fields that are not read only.Instrument.InfoNameTypeVersionBootromCompany IDConfig RevSecurity RevNvol writesLine VoltageWires Freenanodacnanodac2.01.81280102339239.2 v240Figure 4.1.4 Info menu (expanded to show all fields)NameTypeVersionBootromCompany IDConfig RevSecurity RevNvol writesLine voltageWires FreeAllows the user to enter a descriptor of up to 20 characters, using the text entry techniquesdescribed in Section 3.6. The number of characters visible in the display modepages varies according to the number of alarm symbols on display.Nano. Read only display of the instrument model (used by ‘iTools’).Read only. The software version of the instrument.Read only. Instrument software Boot ROM versionRead only. For CNOMO* purposes over Modbus (1280 decimal; 0500 hex).Read only. This value is updated, and a message including this value generated, everytime configuration is quit, if any one or more configuration parameter has beenchanged.Read only. This number is incremented every time configuration is quit, if any one ormore passwords has been changed, or if the FTP Server username has been changed,or if the Comms Enable field has been edited.Number of non volatile write operations for diagnostic purposes.The instantaneous value of the supply voltage applied to the instrument. Used in somecontrol loop operations.This shows the number of wires free to be used. The value takes into account all userwiring whether carried out at the instrument or downloaded from the iTools graphicalwiring editor.Page 62HA030554Issue 7 Nov 12