User Guide - Eurotherm Ltda

NANODAC RECORDER/CONTROLLER: USER GUIDED7 ADVANCED LOOP CONFIGURATION (Cont.)Select configuration menuInstrumentNetworkGroupChannelVirtual ChannelLoopAdvanced LoopMainSetupTuneMaster PIDSlave PIDMaster SPSlave SPOutputDiagnosticsSee Figure D7a forthese menusAdvanced Loop Diagnostics menu(Section 4.7.9)Advanced DiagnosticsMaster ErroeSlave Error(M)Prop. Output(M)Integral Out(M)Deriv. Output(S)Prop. Output(S)Integral Out(S)Deriv. OutputTarget OutputLoop Break (S)Loop Break (M)Sensor Break (S)Sensor Break (M)Sched PBSched TiSched TdSched CBHSched CBLSched MRSched Loop BreakSched Out HighSched Out LowWorking Out LowWorking Out HighMaster FBCalc OPHiSatLimLoSatLimOPPID0.00.000.0000000.000000.0 %NoNo20.0360.0 sec60.0 secAutoAuto0.0 %100 sec100 %-100 %0 %100 %12.70.020.00.012.7Advanced Loop Output menu(Section 4.7.8)Advanced Loop.OutputOutput High 100 %Output Low -100 %Ch1 Output 0.0Ch2 Output 0.0Ch2 Deadband OffRate 15Rate Disable NoCh1 Travel Time 22.0 secCh2 Travel Time 22.0 secCh1 Pot Pos 0Ch1 Pot Brk OffCh2 Pot Pos 0Ch2 Pot Brk OffPot Brk Mode RaiseSbrk Mode SafeSbrk OP 0.0 %Safe OP 0.0 %Manual Mode TrackManual Output 0.0 %Forced Output 0.0 %Manual StartupPff En YesLine Voltage 218 VCool Type LinearFF Type SPFF Gain 1.000FF Offset 0FF Trim Limit’ 100FF OutputTrack OutputTrack EnableRem. Output LowRem. Output High0 %0Off-100 %100 %Figure D7b Advanced Loop menus sheet 2Appendix DPage 342HA030554Issue 7 Nov 12