11.07.2015 Views

User Guide - Eurotherm Ltda

User Guide - Eurotherm Ltda

User Guide - Eurotherm Ltda

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

nanodac RECORDER/CONTROLLER: USER GUIDEF.5 Full driver capabilities listAs a general summary, with the nanodac Ethernet Labview Driver the user can:Configure SensorBreakType and Fault ResponseConfigure Instrument Alarm TypesConfigure Alarm Parameters e.g. (Threshold, Hysteresis, Latching Mode, Blocking)Configure Channel Filter TimeConfigure Humidity parametersConfigure Cool TypeConfigure FeedForward ParametersConfigure Control ActionConfigure Control Loop TypeConfigure ServoToPV and TrackingConfigure Range Low and High LimitsChange Instrument Modes e.g. Operator, Configuration, Auto, ManualConfigure Setpoints (Setpoint1, Setpoint2, Remote Setpoint, Target Setpoint)Configure Dead BandConfigure hysteresisConfigure Safe Output, Manual Output and ManStartUpConfigure Control Output Limits.Configure Valve OperationConfigure Proportional Band Integral Time and Derivate TimeConfigure Cutback Low and High LimitsConfigure Setpoint Low and High LimitsConfigure Setpoint Ramp Rate ValueConfigure Tuning parametersConfigure PID Loop Break TimeConfigure Virtual Channel Timer ParametersConfigure Virtual Channel Totaliser ParametersConfigure Virtual Channel Counter ParametersConfigure Steriliser parametersRead Working Setpoint and Working OutputRead Alarm Output statusRead Manual Output ValueRead Process Variable and Measured ValuesRead Timer StatusRead PID parametersEnable/Disable the Alternative SetpointStart an AutotuneGlobal Acknowledge AlarmsSet Active Setpoint (Setpoint1, Setpoint2)Set Controller Mode (Auto, Manual, OFF)Start Program (Reset, Run, Hold)Read Steriliser ParametersRead Program parametersAppendix FPage 366HA030554Issue 7 Nov 12

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!