User Guide - Eurotherm Ltda

nanodac RECORDER/CONTROLLER: USER GUIDE4.8.4 Programmer Run Menu (Cont.)Prog Time Run The length of time the current program has been running. This value does not includetime spent in Hold, Holdback or WaitingDurationFor Dwell segments only, this is the dwell duration.Ch1 TSP For Ramp and Step segments, this is the current target setpoint for channel 1.Ch1 Time For Ramp segments, this is the configured time for channel 1 to reach it's Target Setpoint(TSP)Ch2 TSPFor Ramp and Step segments, this is the current target setpoint for channel 2. Appearsonly if ‘Channels’ = ‘2’ in the Programmer Set Up menu (Section 4.8.3).Ch2 Time For Ramp segments, this is the configured time for channel 2 to reach it's Target Setpoint(TSP). Appears only if ‘Channels’ = ‘2’ in the Programmer Set Up menu (Section4.8.3)Cycles Left The number of Go Back cycles remaining before the Go Back loop ends.Ch1 User Val The value of user value 1 in the current segment. Appears only if the ‘User Value’ featureis enabled in the Programmer Features menu (Section 4.8.1).Ch2 User Val The value of user value 2 in the current segment. Appears only if the ‘User Value’ featureis enabled in the Programmer Features menu (Section 4.8.1) and if ‘Channels’ = ‘2’ inthe Programmer Set Up menu (Section 4.8.3)Ch1 PV Event The state of channel 1 PV event (Off = Cross symbol, On = Tick). Appears only if the ‘PVEvent’ feature is enabledCh2 PV Event The state of channel 2 PV event (Off = Cross symbol, On = Tick). Appears only if the‘PV Event’ feature is enabled and if ‘Channels’ = ‘2’ in the Programmer Set Up menu(Section 4.8.3).Event 1 to 8 The state of event output 1 to 8 for the current segment (Off = Cross symbol, On = Tick).The number of events appearing is defined in the Programmer Set Up menu (Section4.8.3) (Max Events)End Output The output that is set by the end segment (Off = Cross symbol, On = Tick).Page 132HA030554Issue 7 Nov 12