User Guide - Eurotherm Ltda

More documents

Recommendations

Info

nanodac RECORDER/CONTROLLER: USER GUIDEA2 RECORDER SPECIFICATIONI/O typesFeaturesAnalogue i/pDigital i/pDigital (logic) o/pRelay o/pDC outputFour (eight if dual input option fitted)TwoSee table A2 for optionsSee table A2 for optionsSee table A2 for optionsCSV archive formatEtherNet/IP (Option)File transfer protocol (FTP)MessagesModbus Master (Option)Modbus TCP slaveSet point programmer (option)uhh (history file) archivingUSB port at rear of instrument<strong>User</strong> linearisation tables (four)Two control loops (optional)Advanced Loop (optional)Zirconia probe support (optional)15 Virtual channels (each configurable as maths, totaliser or counter).30 Virtual channels if Modbus Master or EtherNet/IPoptions fitted (no alarms on virtual channels 16 to 30)DefaultOptionsL = Logic output; R = Relay; D = DC outputOP4 and OP5 share Common terminals.Table A2 Output optionsEnvironmental performanceAmbient temperature rangeOperating: 0 to 55°CStorage: -20 to +70°CHumidity range Operating: 5% to 85% RH non condensingstorage: 5% to 85% RH non condensingProtection Front panel (Standard): IP65Front panel (Wash down): IP66, NEMA4X (International)Behind panel: IP10 (International)Shock/VibrationTo BS EN61131-2 (5 to 150 Hz. at 1g; 1 octave per min.)Altitude10ms at 85V RMS supply voltage.Low voltage option: Holdup >10ms at 20.4V RMS supply voltage.Battery backupStored dataSupport time (for real-time clock)Replacement periodTypeTime, date.Minimum of 1 year with unit unpowered.Three years typicalpoly-carbonmonofluoride / lithium (BR2330) (PA260195)Ethernet communicationsType:10/100baseT Ethernet (IEEE802.3)Protocols:Modbus TCP/IP slave, FTP, DHCPCable type Category 5Maximum length100metres (110 yards)TerminationRJ45. Green LED illuminated = link connected; Amber LED flashing shows link activity.Appendix APage 294HA030554Issue 7 Nov 12
nanodac RECORDER/CONTROLLER: USER GUIDEA2 RECORDER SPECIFICATION (Cont.)USB portNumber of portsStandardTransmission speedsMaximum currentPeripherals supportedOne at rear of instrumentUSB1.11.5Mbits/sec (low speed device)95dBCommon mode: >179dBCommon mode voltage250Vac max.Series mode voltage280mV at lowest range; 5V peak-to-peak, at highest range.Input impedanceSee relevant Range specification, below.Overvoltage protection Continuous: ± 30V RMSTransient (
Page 1 and 2:
nanodacUser Guidenanodac recorder/c
Page 3:
Declaration of ConformityManufactur
Page 6 and 7:
nanodac RECORDER/CONTROLLER: USER G
Page 8 and 9:
Page 10 and 11:
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39:
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212 and 213:
Page 214 and 215:
Page 216 and 217:
Page 218 and 219:
Page 220 and 221:
Page 222 and 223:
Page 224 and 225:
Page 226 and 227:
Page 228 and 229:
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
Page 236 and 237:
Page 238 and 239:
Page 240 and 241:
Page 242 and 243:
Page 244 and 245:
Page 246 and 247:
Page 248 and 249:
Page 250 and 251:
Page 252 and 253:
Page 254 and 255:
Page 256 and 257: nanodac RECORDER/CONTROLLER: USER G
Page 348 and 349: NANODAC RECORDER/CONTROLLER: USER G
Page 356 and 357:
NANODAC RECORDER/CONTROLLER: USER G
Page 358 and 359:
Page 360 and 361:
Page 362 and 363:
Page 364 and 365:
Page 366 and 367:
Page 368 and 369:
Page 370 and 371:
Page 372 and 373:
Page 374 and 375:
Page 376 and 377:
Page 378 and 379:
Page 380 and 381:
Page 382 and 383:
Page 384 and 385:
Page 386 and 387:
Page 388 and 389:
Page 390 and 391:
Page 392:
show all

User Guide - Eurotherm Ltda

Create successful ePaper yourself

Delete template?

Save as template?