User Guide - Eurotherm Ltda

nanodac RECORDER/CONTROLLER: USER GUIDE3.4.11 Promote listThis display page allows the user to display up to 10 of the parameters that appear anywhere in the operatorinterface. The parameters can be selected only by using iTools, as described below.Notes:1. ‘Promote List’ must be enabled (in ‘Instrument.Display’ configuration), before it appears in the ‘Goto View’ list.2. There are more parameters visible in iTools than appear at the operator interface. If non-operatorinterface parameters are selected for inclusion in the promote list, they do not appear.3. If parameters which appear only in certain circumstances are selected, then they appear in thepromote list only when they appear in the Operator interface. For example, a channel PV is notvisible unless that channel is enabled (i.e. it is not ‘Off’).PARAMETER SELECTION1. Open iTools and scan for the instrument, (see Section 6).2. Once the instrument has been found, stop the scan. When the instrument has synchronised, click onthe ‘Access’ button near the top of the display to set the unit into configuration mode (a password maybe required).3. Click on the ‘+’ sign to the left of the Instrument folder in the tree list (left-most pane) to expand thefolder. Double-click on ‘Promote List’, to display the Promote list in the main pane. The list contains 20entries, 1 to 10 being for parameters, 11 to 20 being available to the user to add descriptors for parameters1 to 10 respectively.4. Expand further folders, as necessary, to access the required parameters, and click-drag these parametersinto the promote list. Enter a descriptor for the parameter if the default is not as required. As eachparameter is dragged into the list, it appears in the Promote list.5. If the parameters are modified at the operator interface, the changes are reflected in iTools, and viceversa.6. Once all the parameters have been added, it is recommended that the Access button be used to quitconfiguration mode, as otherwise it will not subsequently be possible to quit from the operator interface.Figure 3.4.11 shows typical displays.Promote ListChan 1 TmpT/C 157AChannel.1.Main.UnitsGroup.Recording.EnableChannel.1.Alarm1.Active268.34°CH2O Tmp 12°CYesYesPromote list (iTools)Promote list(Operator interface)Figure 3.4.11 Promote list displays.Page 44HA030554Issue 7 Nov 12