User Guide - Eurotherm Ltda

nanodac RECORDER/CONTROLLER: USER GUIDE4.10 Ethernet/ip Configuration (Cont.)0 Success. Service was successful1 Connection Failed. A connection in the path failed2 Invalid Parameter. A parameter associated with the request was invalid3 Memory Unavailable. No available resources in the server to service the request4 Path Segment Error. The syntax of all or some of the path was not understood5 Path Dest. Error. The path references an unknown object, class or instance6 Partial Transfer. Only part of the expected data was transferred7 Connection Lost. The messaging connection was lost8 Service Unsupported. Undefined service for requested object9 Invalid Attribute. Invalid attribute data detected10 Attribute Error. An attribute in the response has a non zero status11 Already Requested. The object is already in the mode/state being requested12 Object Conflict. The object cannot perform the requested service13 Already Exists. The requested instance or object already exists14 Attribute Error. Request to modify a non modifiable attribute received15 No Privileges. Permission/Privilege check failed16 State Conflict. The current state or mode prohibits the execution of the requested service17 Reply To Large. Response buffer too small for response data18 Fragmented Value. For example this service request will return only half a REAL data type19 Not Enough Data. The service does not provide enough data to complete the request20 Invalid Attribute. Requested attribute is not supported21 Too Much Data. The service supplied more than was expected22 Object Non-Exist. The object specified does not exist in the device23 Seq. Fragmentation. The fragmentation sequence for this service is not active24 No Attribute Data. The attribute data for this object was not saved at the server prior to this request service25 Data Store Failure. The attribute data for this object was not saved due to a failure during the attempt26 Routing Failed. The service request packet was too large for transmission on a network in the path to the destination.The routing device was forced to abort the service27 Routing Failed. The service request packet was too large for transmission on a network in the path to the destination.The routing device was forced to abort the service28 Missing Attribute. The service did not supply an attribute in a list of attributes that was needed by the serviceto perform the requested behaviour29 Invalid Attribute. The service is returning the list of attributes supplied with status information for those attributesthat were invalid30 Embedded Tag Error. An embedded service resulted in an error. This is most commonly an incorrectly formattedtag name31 Vendor Error. A vendor specific error has encountered32 Invalid Parameter. A parameter associated with the request was invalid33 Write Once Error. An attempt to write to a write once only parameter occured34 Invalid Reply. An invalid reply was received35 Buffer Overflow. The message received is larger than the receiving buffer36 Format Error. The format of the received message is not supported37 Key Path Failure. The key segement in the path does not match destination key38 Path Size Error. The size of the path in the request is too large39 Unexpected Attribute. Unable to set the attribute at this time40 Invalid Member Id. The requested member id does not match class object41 Member Is R/O. A request to modify a R/O member was received42 Group 2 Server. Group 2 DeviceNet server response43 Translation Error. A CIP modbus translator request failed44 Attribute Is R/O. A request to read a non readable attribute was received64 No Tags Found. There were no tags configured in the input or output tables65 Invalid Config. The total length in characters of all the tags in this table will cause the PLC to exceed its internalbuffer of 500 bytes. To eliminate this problem, reduce the length of some or all tag namesTable 4.10.1 Tag Status code definition* Temperature units are those configured for the channel to which the temperature measuring transducer is connected.Page 144HA030554Issue 7 Nov 12