User Guide - Eurotherm Ltda

nanodac RECORDER/CONTROLLER: USER GUIDE4.8.1 Programmer Features Configuration (Cont.)EventProgram RunProgram EndProgram HoldProgram ResumeProgram ResetSegment StartAdvanceHoldbackPV EventMessage: Run: Complete: : Hold: : Resume: : Reset: : Segment Start: : Advanced: : Holdback:Channel No.: : PV Event:Channel No.Table 4.8.1 Programmer messagesFTP StoreIf this feature is enabled, an FTP menu item appears in the top level Programmer configurationmenu. ‘FTP’ allows the user to enter communications parameters for the hostcomputer which is to act as the ftp server.FTP Store allows the user to set-up a centralised program store from which several instrumentscan select their program.Notes1 A maximum of 100 entries is supported on all drives. Directory trees are supported for both USBand FTP, and if the root of the drive contains only files (no directories), then up to 100 files arelisted. If the root of the drive contains directories then each directory can contain 100 entries (butone of these entries will be taken up by '..' to return to the directory above).2 Program files are in compressed XML (.uipz) file format.3 When a program is selected from an FTP server a local copy of the program file is made withinthe instrument before being processed. It should be noted that the number of program files inthe internal 'user' drive does not affect this local copy, and therefore a program from an FTP servercan be loaded, even when the internal user drive is full.4 As the loaded program resides in the current program database it is automatically included in aclone file. In addition, program files stored in the internal program drive are included in a clonefile (refer to ‘Cloning’, below).5. On the internal program drive only a flat directory structure is supported. However, full tree directoriesare supported on both the USB memory stick and FTP server (accessed via the HMI File Explorer).6. It is not possible to store program files on an external device. Programs selected from an externaldevice can, however, be stored in the internal program store.7. It is not possible to select a program from an external device over comms and iTools.CLONINGEach program file stored locally on the instrument IS included in a clone file as a Binary Large Object (BLOB),similar to the Graphical Wiring Editor layout. Each program file BLOB contains the program filename.When loading a clone file, existing programs in the instrument’s internal drive are deleted, and program fileBLOB(s) in the clone are reformatted into program files by the instrument.Page 126HA030554Issue 7 Nov 12