Frequency Inverter DF51... - Moeller.com.tr

04/07 AWB8230-1541GB Displayed value (selection withPNU b089)PNU Run b031= 10Meaning Value range DS Page Required settingsC076 – j Communication –behaviour of frequencyinverter on<strong>com</strong>munication errorsC077 – j Communication – setmonitoring time(watchdog).C078 – j Communication –waiting time (latencybetween request andresponse)00: Switch off on fault signal E60 02 147 Individual01: Decelerate to standstill atdeceleration ramp and thenswitch off with error E60.02: No fault signal03: FRS: Free run stop (free coasting,= controller inhibit)04 DEC: Braking to 0 Hz at setdeceleration ramp0…99.99 s 0.00 147 Individual0…1000 ms 0 147 IndividualDisplayed value (selection with PNU b089)When you operate the DF51 frequency inverter through the serialinterface with a fieldbus module (Modbus, CANopen,PROFIBUS DP) or an external keypad (DEX-KEY-…), the built-inkeypad is disabled. Only the Stop key remains enabled, but canalso be disabled with parameter b087. With PNU b089 you canselect a parameter to be displayed (d001 to d007) on the built-inkeypad’s display.Table 38: Selecting a display value in operation through the serial interface (PNU b089)Value Function Description Value range01 d001 Output frequency 0.0…400.0 Hz (0.1 Hz)02 d002 Output current 0.0…999.9 A (0.1 A)03 d003 Direction of rotation • F: Clockwise (forward) rotatingfield• o: STOP• r: Anticlockwise (reverse)rotating field04 d004 PID feedback 0.00…99.99 (0.01 %)100.0…999.9 (0.1 %)1000…9999 (1 %)05 d005 Status of digital inputs 1 to 5 –06 d006 State of digital outputs 11, 12 and relay K1 –07 d007 Scaled output frequency 0.00…9999 (0.01/0.1/1/10 Hz)When operating through the serial interface, observe thefollowing:• DF51 shows the value of d00x as selected with PNU b089 if:– DIP switch OPE/485 is set to 485;– the frequency inverter is connected through the serialinterface when the supply voltage is connected (POWER).• During operation through the serial interface, the received faultsignals (E xx, ) are displayed regardless of the setting inPNU b089. You can acknowledge the fault signal with the Stopkey or the Reset function (RST, a section “Resetting faultsignals (RST)”, page 183).• You can disable the Stop key with PNU b087.147