Frequency Inverter DF51... - Moeller.com.tr

Using the DF5104/07 AWB8230-1541GBTable 17:Indication parameterPNU Designation Functiond001 Output frequency display Displays the output frequency in Hertz (Hz). The Hz LED is lit.d002 Output current display Displays the output current in amperes (A). The A LED is lit.d003 Direction of rotation display Display:• F for clockwise operation (forward)• r for anticlockwise operation (reverse)•o for stopd004 PID feedback display Indication in % if PID control enabled. The factor is set with PNU A075. Default is 0.00.d005d006d007Indication – status of digitalinputs 1 to 5Indication – status of digitaloutputs 11 and 12, and relay K1Indication – scaled outputfrequencyExample: Digital inputs 1, 3 and 5 are activated. Digital inputs 2 and 4 aredeactivated. Digital inputs 2, 4 and 6 are disabled.6 5 4 3 2 1Example: Digital output 11 and relay output (N/O contact K11-K14) areenabled. Digital output 12 is deactivated.K14 12 11Indication of the product of the factor (PNU b086) and the output frequency.Examples:• Maximum output frequency 50 Hz• Factor PNU b086 = 25• Indication 1500, corresponds with the synchronous speed of a four-pole motor.d013 Indication – output voltage Indication of motor voltage at 50 Hz in volts (V).d016Indication – operation timecounterTotal time in hours in which DF51 is in RUN operation.d017 Indication – mains On time Total time in hour in which DF51 was live (mains, internal DC link) (Power display).d080d081Indication – total number ofoccurred faultsIndication – fault 1 (last faultsignal)Total number of detected fault signals (E…).Indication of last fault signal. The fault register contains the operational data (current, voltage,frequency, etc.) at the time of the fault.d082 Indication – fault 2 Display of fourth from last fault message. The fault register contains the operational data (current,voltage, frequency, etc.) at the time of the fault.d083 Indication – fault 3 Display of third from last fault message. The fault register contains the operational data (current,voltage, frequency, etc.) at the time of the fault.hIf the DF51 frequency inverter is connected to a field bus(CANopen, PROFIBUS-DP) or an external keypad throughthe serial interface, use PNU b89 to call up the displayparameters (section “Displayed value (selection withPNU b089)”, page 147).58