Frequency Inverter DF51... - Moeller.com.tr

04/07 AWB8230-1541GB KeypadExamples for changing parametershThe following example assumes the default settings.Changing the acceleration time 1: PNU F002The frequency inverter is in display mode: LED POWER is lit and thedisplay shows 0.0 Hz a.The value 0.0 appears again in the display and the Hz LED lightsup. You have reduced the acceleration time from 10 s to 5 s.You can also change the parameter values of groups B and C andH as described in the example.aPRGPRGbPRGENTERPRGFigure 60: Change acceleration time 1a Display value (default setting = 0.0 Hz)b Parameter holding the displayed value aX Press the PRG key.The display changes to d001.X Press the Down key seven times until F002 appears on thedisplay.X Press the PRG key.The PRG LED lights up.The set acceleration time 1 in seconds appears on the display(default value: 10.00).X With the Up and Down arrow keys change the set values, forexample to 5.00.Hold the Down key to change the display value at logarithmicallyincreasing step widths.There are now two possibilities:X Press the ENTER key to save the displayed value.Press the PRG key to save the displayed value to non-retentivememory. When the power supply is switched off (LED POWER off),the value is lost.F002 appears in the display and the LED PRG goes out.X Press the Up key seven times until d0001 appears.X Press the PRG key.59