Frequency Inverter DF51... - Moeller.com.tr

POWERALARMRUNPOWERALARMRUNALARMPRGFWD REVPOWERRUNALARMPRGFWD REVPOWERRUNALARMPRGFWD REVPOWERRUNPOWERALARMRUNPOWERALARMRUNPOWERALARMRUNALARMPRGPOWERRUNALARMPRGFWD REVPOWERRUNAppendix04/07 AWB8230-1541GBCopy and Read function example<strong>Frequency</strong> inverter (A) with connected and configured keypadDEX-KEY-10.The parameters of frequency inverter (A) are configured for theconnected drive unit (application, series machine).The table below describes the steps required to copy theparameters of frequency inverter (A) to three further, identicalfrequency inverters (B, C and D), with the same application (driveunit):Step Key Description Data transfer1 The parameters saved in the frequency inverter (A) are read into theREAD keypad.2 Switch off the power supply of frequency inverter (A) anddisconnect the LCD keypad’s connection cable from the frequencyinverter.(A)ARMT READ COPYMNT PRG ENTERFWD REV3 Connect the keypad’s connection cable to frequency inverter (B)and switch on the frequency inverter’s power supply.4 1) The parameters saved to the keypad are copied to frequencyCOPY inverter (B).This takes about 10 seconds.RMTREAD COPYMNT PRG ENTERA(B)5 Switch off the power supply of frequency inverter (B) anddisconnect the LCD keypad’s connection cable from the frequencyinverter.6 Repeat steps 3 to 5 with frequency inverters (C) and (D).COPYRMTREAD COPYMNT PRG ENTERA(C, D)1) Note on step 4If individual parameters are changed after you have pressed the COPY key (for example the acceleration time), you can carry out step 4a here withoutchanging the keypad’s saved data.4aRMTAfter issuing the COPY <strong>com</strong>mand, you can use the keypad tochange the copied parameters of frequency inverter (B). Thechanged data is automatically saved to frequency inverter (B).The keypad’s memory content is not affected by this operation.RMT READ COPYMNT PRG ENTERA(B)To also use the parameters changed in step 4a for frequency inverters (C) and (D), copy them to the keypad.4bREADThe parameters saved in the frequency inverter (B) are read into thekeypad.This overwrites the parameters saved in step 1 so that the keypadnow contains the parameters changed in step 4a.B)ARMT READ COPYMNT PRG ENTER208