Frequency Inverter DF51... - Moeller.com.tr

Setting parameters04/07 AWB8230-1541GBPNU Designation RUN b031= 10Value Function DSA096A296Decelerationtime, frequencyfor changeoverfrom ramptime 1 to ramptime 2– – 0.0…400 Hz Here, set a frequency at which the changeover from the first to thesecond deceleration time is to take place.0.0A097Accelerationtime,characteristic– – Here, you can set a linear or an S-curve acceleration characteristic for motor acceleration(first and second time ramp):f0000A098F002F202F003F203Decelerationtime,characteristicAccelerationtime 1Decelerationtime 10100 Linear01 S curve– – 00 Linear 0001 S curvej j 0.01…3000 s Resolution of 0.01 s at an input of 0.01 to 99.99Resolution of 0.1 s at an input of 0.1 to 999.9Resolution of 1 s at an input of 1000 to 3000j j 0.01…3600 s Resolution of 0.01 s at an input of 0.01 to 99.99Resolution of 0.1 s at an input of 100.0 to 999.9Resolution of 1 s at 1000 to 3600 st10.0010.00If the deceleration ramp is to have different changeover times fromthe acceleration ramps, use the “second parameter set”<strong>com</strong>mand.Example:X Parameterize as follows:– PNU C004 = 08 (SET, second parameter set selected)– PNU C005 = 09 (2CH, second time ramp)2CHSETREVFWD5 4 2 1P24Figure 93:Digital input 5 = 2CH (second time ramp), digital input4 = SET (second parameter set)90