Temperature Controller - Staveb AG

Parameter Functions and Definitions 5-41Communication SettingFunction GroupThis function group allows you to configure the controller’s communicationparameters, enabling interface to a personal computer that is running the900Builder software application. The controller hardware must supportcommunications. For the controller cat. nos. that have RS-485communications, see Table 1.A.Figure 5.12Power ONOperationfunction groupkeyless than1 sec.Adjustmentfunction groupkey1 secondmin.key 3 seconds min.key Flashes at 1 sec. min.ControlstopInitial settingfunction groupkeyless than1 sec.Communicationssetup functiongroupControl in progressControl stoppedCommunications Unit No.,Baud Rate,Communications Data Length,Communications Stop Bit,Communications ParityConditions of Use: Communications function must be supported by thecontroller.Function: These parameters allow you to match the communicationsspecifications of the controller(s) with the personal computer which has the900Builder software. If a 1:N connection is being used (RS-485), ensure thatthe communications specifications for all devices in the system are the sameexcept for the unit number. Each device needs an individual unit number forRS-485 communication.Note: Each parameter is enabled when the power is reset.Publication 900-UM003C-EN-E - January 2004