Temperature Controller - Staveb AG

Parameter Functions and Definitions 5-9During heating and cooling control, the manipulated variable on the controloutput 2 side (OUT 2 terminal output) is monitored. Table 5.K shows outputto control mode assignment.Table 5.JControl Monitor Range UnitsHeating and cooling 0.0…100.0 %Related Parameters• Standard/Heating And Cooling (Initial Setting function group) (p. 5-23)• Manipulated Variable Display (Advanced Setting function group)(p. 5-37)Table 5.K Output to Control Mode AssignmentSettingOutputControl Mode Direct/ReverseOperationControl Output 1 Control Output 2(ALM1)Standard control Reverse operation Control output (heat) —Standard control Direct operation Control output (cool) —Heating and cooling Reverse operation Control output (heat) Control output (cool)controlHeating and coolingcontrolDirect operation Control output (cool) Control output (heat)Adjustment Function GroupThis function group is for executing AT (auto-tuning) or setting up thecontrol.This function group provides you with basic controller setup parameters forPID (Proportional Band, Integral Time, Derivative Time).Figure 5.4Power ONOperationfunction groupkeyless than1 sec.Adjustmentfunction groupControl in progressTo move to the Adjustment function group from the Operation functiongroup, press the key for less than 1 second.Publication 900-UM003C-EN-E - January 2004