Temperature Controller - Staveb AG

Configuration and Basic Operation 3-152. The Input Type is displayed. When you are monitoring/configuring theInput Type for the first time, the set value is 0: K type thermocoupledefault. (0 is set if you have a platinum resistance thermometercompatible controller [see Table 1.A].) To select a different sensor, pressthe U or D keys. This changes the Set Value (see Table 3.A) to matchyour desired sensor input.Figure 3.19Initial setting function groupInput type3. Select the Temperature Unit parameter by pressing the M key. Note:The default is c: °C. To configure f: °F, press the U key.Figure 3.20Temperature unit4. Select the Control Period (OUT1) parameter by pressing the M key.Note: The default is 20.Figure 3.215. Select the Direct/Reverse Operation parameter by pressing the M key.Note: The default is or-r: reverse operation. To select or-d: directoperation, press the U key.Figure 3.22Control period(OUT1)6. To return to the Operation function group press the key for at least1 second.Figure 3.23Operation function groupPV/SPDirect/reverseoperationNote: The newly configured value or parameter is loaded into controllermemory if you do not operate any key on the front panel for at least 2 secondsor by pressing the or M key.Publication 900-UM003C-EN-E - January 2004