Hardware and Engineering DF6-340-... Frequency ... - Moeller.com.tr

Programming the ControlSignal Terminals01/02 AWB8230-1413GBRunning time (RNT) <strong>and</strong> Mains On time (ONT)The <strong>DF6</strong> frequency inverter counts the time for which it is in RUNmode (the running time) <strong>and</strong> time for which it is connected tomains power V LN (the Mains On time). The relay outputconfigured as RNT be<strong>com</strong>es active when the running time setunder PNU b034 is exceeded. The relay output configured as ONTalso accesses parameter PNU b043. The ONT output be<strong>com</strong>esactive when the <strong>DF6</strong> is connected to the supply voltage V LNlonger than the time set under PNU b043. You can configureeither one of the relay outputs as RNT or ONT, but not both at thesame time.X Program one of the relay outputs K23-K24 or K33-K34 as RNTby entering the value 11 in the corresponding PNU (C021 orC022) or in PNU C026 for signalling relay contacts K11-K12.ONTK23 K245...30 V 0. 250 V DFigure 100: Relay output K23-K24 ONT (Mains On time)RNTK23 K245...30 V 0. 250 V DFigure 98:Relay output K23-K24 configured as RNT (running time)U LNPNU b034ONTFWD/REVRNTFigure 99:Function chart for RNT (running time)PNU b034Figure 101: Function chart for ONT (Mains On time)U LN : Supply voltageX Program one of the relay outputs K23-K24 or K33-K34 as ONTby entering the value 12 in the corresponding PNU (C021 orC022) or in PNU C026 for signalling relay contacts K11-K12.PNU Name Adjustable in RUN mode Value Function WENormalExtendedb034Running timeor Mains Ontime exceeded– j 0 to 65530 h When the time entered her is exceeded, either the digitaloutput configured as RNT (running time) or the digitaloutput configured as ONT (Mains On time) be<strong>com</strong>es active.0100