Hardware and Engineering DF6-340-... Frequency ... - Moeller.com.tr

Programming the ControlSignal Terminals01/02 AWB8230-1413GBMatching analog input O2figure 51 shows the matching possibilities for setpoint voltagesfrom –10 to +10 V.The associated operating range is specified with PNU A113 <strong>and</strong>A114 for the voltage, <strong>and</strong> with PNU A111 <strong>and</strong> A112 for thefrequency. At a zero value, the setpoint polarity, <strong>and</strong> therefore thedirection of rotation, are reversed. If the input voltage falls belowthe value specified in PNU A113, the <strong>DF6</strong> frequency inverteroutputs the frequency specified in PNU A111; if the input voltageis higher than PNU A114, the <strong>DF6</strong> outputs the frequency specifiedin PNU A112.–10 V–100 %PNU A113f[Hz]PNU A004PNU A1120 PNU A114 +10 V+100 %PNU A111U O2-LPNU A004Figure 51:Setpoint matching, terminals O2LPNU Name Adjustable in RUN mode Value Function WENormalExtendedA111End frequencyon directionreversal,input O2– j –400 to400 HzHere, the end frequency that corresponds to the voltagesetpoint value specified under PNU A113 is set.0.00A112End frequency,input O2– j –400 to400 HzHere, the end frequency that corresponds to the voltagesetpoint value specified under PNU A114.0.00A113Maximumsetpoint voltageat directionreversal,input OI– j –100 to+100 %The minimum setpoint value entered here is a percentageof the highest possible setpoint voltage (–10 V to +10 V).–100A114Maximumsetpointvoltage,input OI– j –100 to+100 %The maximum setpoint value entered here is a percentageof the highest possible setpoint voltage (–10 V to +10 V).10064