Hardware and Engineering DF6-340-... Frequency ... - Moeller.com.tr

Programming the ControlSignal Terminals01/02 AWB8230-1413GBName Value 1) Function DescriptionFA3 06 <strong>Frequency</strong> reached (1) The FA3 signal is issued when the output frequency lies in the frequency range defined underPNU C042 <strong>and</strong> C043 (plus tolerance).IP 8 Mains failure,The IP signal is issued on intermittent mains failure.immediate stopUV 9 Undervoltage signal The UV signal is output on undervoltage.RNT 11 Running time exceeded The RNT signal is output when the Running time set under PNU b034 is exceeded.ONT 12 Mains On time exceeded The ONT signal is output when the Mains On time set under PNU b034 is exceeded.THM 13 Motor thermal overload The THM signal is output when the motor overload warning threshold set under PNU C061 isexceeded.Signalling relay 2)K11 – Signalling relay contacts During normal fault-free operation, terminals K11K14 are closed. If a malfunction occurs or theK12K14supply voltage is switched off, terminals K11K12 are closed.Maximum permissible values:• 250 V ~; Maximum load 2.5 A (purely resistive) or 0.2 A (for a power factor of 0.4)•30VH; Maximum load 3.0 A (purely resistive) or 0.7 A (for a power factor of 0.4)• Minimum required values: Minimum required values: 100 V ~ at a load of 10 mA or 5 V H at aload of 100 mA1) To activate the function, enter this value in the corresponding parameter.2) This output can be used as both a signal output <strong>and</strong> a normal digital output.56