Hardware and Engineering DF6-340-... Frequency ... - Moeller.com.tr

01/02 AWB8230-1413GB OverviewName Value 1) Function Description<strong>Frequency</strong> setpoint inputh – 10 V setpoint voltage forexternal potentiometerPESHOOILR: 1 to 10 kOResolution: 12-bitO – Analog input for setpointfrequency throughvoltage signal(0 to 10 V H)PESO+OIL–Input impedance: 10 kOI F 20 mAResolution: 12-bitO2 – Analog input for setpointfrequency throughvoltage signal(–10 to +10 V H)PESO2LInput impedance: 10 kOI F 20 mAResolution: 12-bitOI – Analog input for setpointfrequency throughcurrent signal(4 to 20 mA)L – 0 V reference potentialfor setpoint inputsAnalog outputsThe OI input for a setpoint value from 4 to 20 mA is used onlywhen the digital input configured as the AT input is closed.Load resistance: 250 OResolution: 12-bitIf no digital input is configured as an AT input, the setpoint values O <strong>and</strong> OI are added together.FM – <strong>Frequency</strong> output You can assign the following variables to outputs AM, AMI <strong>and</strong> FM:AM – Voltage output(0 to 10 V, 8-bit)AMI – Current output(4 to 20 mA, 8-bit)–10 V...+10 V 0 VOutput frequency, motor current, torque, output voltage, input power, ramp frequency <strong>and</strong>thermal load ratioL – 0 V 0 V reference potential for the analog outputProgrammable relay outputs K23 to K34RUN 00 RUN signal The RUN signal is output during operation of the motor.FA1 01 Signal when frequency is fsreachedPESOI+L–f 2f 1FA1FA2FA2 02 Signal when frequency isexceeded (1)f s = setpoint frequencyIf a digital output is configured as FA1, a signal is issued as long as the setpoint value is reached.If a digital signal is configured as FA2, a signal is output as long as the frequencies defined underPNU C042 <strong>and</strong> PNU C043 are exceeded.OL 03 Signal on overload The OL signal is output when the overload alarm threshold (adjustable under PNU C041) isexceeded.OD 04 Signal on PID control The OD signal is output when the PID control deviation set under PNU C044 is exceeded.deviationAL 05 Signal (alarm) on fault The AL signal is issued when a fault occurs.55