Hardware and Engineering DF6-340-... Frequency ... - Moeller.com.tr

Contents01/02 AWB8230-1413GB4 Operating the <strong>DF6</strong> 45Initial startup 45Keypad 46Operation with LCD keypad 46– Menu overview 47– Changing display <strong>and</strong> Basic parameters 48– Changing the parameters of the extendedparameter groups 48Display after the supply voltage is applied 49Connection examples 50– Operation using an external potentiometer 50– Operation through an analog setpoint value 50– Operation with fixed frequencies 51Operational warnings 525 Programming the Control Signal Terminals 53Overview 53Analog outputs – AM, AMI <strong>and</strong> FM 57– Voltage output (AM) 57– Current output (AMI) 58– <strong>Frequency</strong> output (FM) 58Analog inputs terminals O, O2 <strong>and</strong> OI 60– <strong>Frequency</strong> setpoint definition 60– Matching of terminals O, O2 <strong>and</strong> OI 61– Analog setpoint value matching 62Programmable digital inputs 1 to 5 65– Start/stop 67– Fixed frequency selection (FF1 to FF4) 68– Bitwise fixed frequency selection (SF1 to SF7) 70– Analog input changeover (AT) 72– Second time ramp (2CH) 73– Controller inhibit <strong>and</strong> coasting (free run stop – FRS) 74– External fault message (EXT) 75– Unattended start protection (USP) 76– Reset (RST) 77– Jog mode (JOG ) 78– PTC/NTC thermistor input, terminal TH 80– Software protection (SFT) 81– Motor potentiometer functions: accelerate (UP) –decelerate (DWN) – reset frequency (UDC) 82– Use second parameter set (SET) 84– Activate DC braking (DB) 85– Change over current limit (OLR) 87– Heavy mains starting (CS) 88– Setpoint value through keypad (OPE) 90– Three-wire control (STA – STP – F/R) 91– Activate/deactivate PID control Reset PID <strong>and</strong>integral <strong>com</strong>ponent (PIDC) 92Programmable relay outputs K11 to K34 93– Signalling relay terminals K11, K12, K14 93– Relay outputs K23-K24 <strong>and</strong> K33-K34 94– <strong>Frequency</strong> arrival signal (FA1/FA2/FA3) 942