Hardware and Engineering DF6-340-... Frequency ... - Moeller.com.tr

Programming the ControlSignal Terminals01/02 AWB8230-1413GBCurrent output (AMI)The AMI terminal provides the variables listed in the table belowin the form of a 4 to 20 mA current signal.X In PNU C029, specify the variable which the AMI terminal is toprovide.X In PNU C087, specify the gain factor <strong>and</strong> in PNU C088 theoffset.PNU Function Adjustable in RUN mode Value Function WENormalExtendedC029C087C088Output, AMIterminalGain, AMIterminalOffset, AMIterminal– j 00 Output frequency: 0 Hz to end frequency PNU A004(a section “End frequency”, page 108)01 Output current: 0 to 200 %04 Output voltage: 0 to 100 %05 Inverter input power: 0 to 200 %06 Thermal load ratio: 0 to 100 %07 Ramp frequency: 0 Hz to end frequency PNU A004(a section “End frequency”, page 108)j j 0 to 255 Current output gain 80j j 0 to 20 mA Current increase 0.000<strong>Frequency</strong> output (FM)The FM terminal provides the variables listed in the table below inthe form of a pulse-width modulated (PWM) signal (a fig. 46).An exception is the output frequency to which the value “03” isassigned which is output as a frequency modulated (FM) signal(a fig. 48).X In PNU C027, specify the variable which the FM terminal is toprovide.X In PNU B081, specify the gain factor.PNU Function Adjustable in RUN mode Value Function WENormalExtendedC027b081Output, FMterminalGain, FMterminal– j 00 Output frequency: PWM signal 0001 Output current03 Output frequency: FM signal04 Output voltage05 Inverter input power06 Thermal load ratio07 Ramp frequencyj j 0 to 255 Gain of the frequency output 6058