Hardware and Engineering DF6-340-... Frequency ... - Moeller.com.tr

01/02 AWB8230-1413GB Start/stopPNU Name Adjustable in RUN mode Value Function WENormalExtendedA002 Start signal – – 01 The signal for starting the motor is issued through the digitalinputs configured as FW or REV.A038A039<strong>Frequency</strong> injog modeType of motorstop in jogmode02 The signal for starting the motor is issued by the ON key onthe keypad.j j 0 to 9.99 Hz The frequency to be applied to the motor in jog mode. 1.0– j 00 Stop signal active: the motor coasts to halt 0001 Stop signal active: the motor is decelerated to st<strong>and</strong>stillunder a deceleration ramp02 Stop signal active: the motor is decelerated to st<strong>and</strong>stillunder DC braking03 Jog mode without prior motor stop: the motor coasts to halt04 Jog mode without prior motor stop: the motor is deceleratedto st<strong>and</strong>still under a deceleration ramp05 Jog mode without prior motor stop: the motor is deceleratedto st<strong>and</strong>still under DC braking01hhOperation in jog mode is not possible when the joggingfrequency set under PNU A038 is less than the startfrequency set under PNU b082 (a section “Run signal(RUN)”, page 96).Jog mode can only be activated when the frequencyinverter is in the Stop state if the values 00 to 02 havebeen set under PNU C039.79